I know you wont beleive me but...

[Apollo2]

THIS IS NOT NORMAL

The bearing in my Sine // Saw is broken. And very stuck. I coould get a bearing out of an oscrillatrix, g funk, Angle, and popstar but this is bad.

I think theres something wrong. Freezing and wiggling and prying with a knife occasionally has yet to fail me.

I heard that holding the tool with pliers will work, but it is on the side with the axle.

So can someone either tell me some crazy way to get out bearings or how to remove stax?

I have also tried supbreh’s WD40 Method.

[yoyospirit]

Use the end of a drill bit that’s the size of the inner diameter of the bearing. Worst comes to worst, just send the yoyo to me and I can get the bearing out for just shipping back.

[Apollo2]

@yoyospirit

Use the end of a drill bit that’s the size of the inner diameter of the bearing. Worst comes to worst, just send the yoyo to me and I can get the bearing out for just shipping back.

I cant, the axle is in the way. How do i remove the stax?

[yoyospirit]

@Apollo2

@yoyospirit

Use the end of a drill bit that’s the size of the inner diameter of the bearing. Worst comes to worst, just send the yoyo to me and I can get the bearing out for just shipping back.

I cant, the axle is in the way. How do i remove the stax?

Take a hammer and lightly tap the axle until you feel the STAX fall out.

[nardcopter]

I push them against the table until it pops out, but that can be dangerous.

[Apollo2]

Thx guys. I GOT IT OUT!!! WOOOOOOOOOOOOOOOO