Made some revisions to this design, for now it’s called the “Two Step”. Most of the changes are inside the cup - the indentations have angles instead of steep walls, and the rim has more work done to it.
The catch-zone area of the rim has a lot of options, though. I added an indented ring where it transitions from inverse to round, similar to designs like the CLYW Compass. I also had some ideas for the round part.
Here there is a round part, with a flat part right near the edge.
This version is fully round. It’s simple, at least?
This version is all angles! It’s probably a bit too much. I had been playing with an UNPRLD Abduction all day.
All of these are around 63.5g assembled, 46mm width, 56mm diameter, 8mm axle. The body material is 7075 Aluminum.
I feel like I want to make 100 tweaks before I get this prototyped (just a one-off run).