I usually form a temporary cone with tape and cardboard to attach to the end of the Motorsil D tube when I re-silicone yoyo response. Today it was a huge pain, though. Unlike other flowable silicone, Motorsil D does not come with a nozzle. Anyone know what nozzles fit on Motorsil D tubes?
I can measure it and figure it out, maybe. But I was hoping someone might now…
If you have a 3D printer I can send you my model I am using.
Hey thanks, but I don’t have access to a 3d printer. I take it you had the same issue, too?
Yes. I have no clue if there is a buyable solution to it.
I wanted to have something with a shorter nozzle since everything is just drying in these long ones.
Do you happen to have the measurements for it? If it’s not handy, now worries, I’ll measure it myself.
I threw away the last bit of a tube of Motorsil D today because my makeshift nozzle came apart and sili was oozing everywhere. What a mess. Anyways, I have a fresh tube left and need to get a nozzle for next time.
I guess you refer to the tube cap (not sure what the correct word is for it)?
10.8mm x 5.4mm (height is just what I use for my model)
Thanks!!
