Silicon?

[Peaceful]

So, I’m planning to buy a tube of silicon and a YYJ Legacy, But I just want to make sure… (I can’t buy pads, that’s why…)

Where will I put/store the silicon?, so that it wont dry/cure in the next hours? Is it possible?

and is there something that I will put (cover) in the tip of the nozzle so that the silicon wont dry?

[Apetrunk]

I’ve found that putting a piece of duct tape or two over the end of the nozzel will limit the curing of the silicone in the nozzle, but I sometimes do need to take the nozzle off to get the cured stuff out.

If you happen to have a vaccuum chamber, that might be good for storing the tube in, but just anywhere should be fine.

[Brad]

Some people use a nail in the end of the small tubes; I just clean it off and put the cap back on.

[Smoke770077 (Mitch)]

@10 10010 1001 1 1110

I’ve found that putting a piece of duct tape or two over the end of the nozzel will limit the curing of the silicone in the nozzle, but I sometimes do need to take the nozzle off to get the cured stuff out.

If you happen to have a vaccuum chamber, that might be good for storing the tube in, but just anywhere should be fine.

mega lolz x1400000000000000000000000000000000000000000000

[Yo-Yo-Joe]

@Mitch

@10 10010 1001 1 1110

I’ve found that putting a piece of duct tape or two over the end of the nozzel will limit the curing of the silicone in the nozzle, but I sometimes do need to take the nozzle off to get the cured stuff out.

If you happen to have a vaccuum chamber, that might be good for storing the tube in, but just anywhere should be fine.

mega lolz x1400000000000000000000000000000000000000000000

What’s so funny? That’s where I have all my yoyo supplies. ;D