Hi guys, I just got a c3 capless and I put too much thread on the axle to tune it and the side for the hex key is stuck in the yoyo, what’s the best way to get it out? I can’t access the hex key hole to get it out. And is there suppose to be a small bump in the middle of the throw in the side that doesn’t have the engraving? Thanks!
Double nut method. Just go to the hardware store and find two small nuts that fit properly on the axle. Tighten them against each other and unscrew using a wrench. Safest method and easiest in my opinion. Good luck!
Double Nut method to Remove an Axle
Or use a pliers and get a new axle.
Ok, well also, anyone can answer my other question? And I will try the double but method. What is the most common nut size for axles to do it with?
I believe you want to look for an M4
So look for a metric size 4 nut by .07 correct?
yup
But take the yoyo along with to make sure it’s the right size.
And NO FORCING!
Hook the axle up to ur drill chuck
This is very easy and quick.
The DN method has never worked for me, but that’s just me!
If you don’t have a drill then forget anyone mentioned it ;).