hey guys, I was just wondering if it is possible to hubstack a yyf DV888? And if it is, how could you?

yep, I have done this twice. take an axle out of a pgm. put it in the dv888 to where the ends are sticking evenly out both ends. then take some pliars and pull the hubstack post out. screw it on to the ends of the axle in the dv888. then put on bearings, o-ring , and hubstack.
hope this helps, jeffrey

ok thanks, but can you still unscrew the two halves when the hubstacks are on


Be REALLY, REALLY careful when screwing in the PGM axle, because you very well might strip the threads in the yoyo.

Something I found on a different forum;