Hello, i’m trying to figure out what type of bearing my bushido uses. It’s been in a box for the better part of two decades and I’d like to get it another one.
2 Likes
Is that ceramic?
Those look like Duncan spacers so it’s most likely a size A bearing. I would measure the diameter of the bearing to be sure. Also most buzz on yo-yos used an spr system so you might want to look into getting one of those.
That’s the small yyj size bearing, I’m not sure what letter that is.
3 Likes
looks like the bearing form a superyo renegade.
I think you’re spot on. Looks like it might be size B.
1 Like
I don’t believe I would’ve bought a ceramic bearing for it. So I don’t think so, unless it happened to come with one brand new.
No, I meant the yoyo itself! The orange looks like ceramic glaze.
Thank you. I think that’s it.
1 Like
I played with it so much back in the day that I’ve worn off parts of the orange that’s on the yo-yo
looks like buzzon dyed it orange.
3 Likes
A lot of buzzon yoyos used Spintastic shells and bearing assemblies. That looks more like the standard Spintastics bearing assembly. The gray marble yoyo shown below is an Element X with rubber rings made for MWR. It has the SPR kit with a B size bearing. You can see the SPR plate is larger than the Duncan sticker The red yoyo is a Spintastics SST Revolver with the standard Spintastics bearing assembly with a B size bearing. It looks very similar to the orange yoyo shown.
Also, I didn’t know Bushidos were available with the smaller bearing mount shown. I thought they all came with the larger SPR kit.
1 Like
The buzzon bootleg used spintastics shells. The element x/bushido/blaze all used the same shell, from a different mold.
1 Like