i have cleaned my bearings, swithed them, and lubed them on my yomega glide and it still becoming responsive. the same problem with my onedrop vanguard any help???
How much lube did you use? Lube will make a yoyo responsive.
half a drop on both sides
Probably too much lube. You only need a very tiny amount and usually applied from one side is sufficient. Did you remove the shields to clean & lube?
There’s some useful info here if you haven’t seen it: Useful modification & maintenance guides -- clean, repair, tune, fix yoyos - Yo-Yo Mods and Maintenance - YoYoExpert
ive done all the cleaning steps properly. it just keeps grabbing when i pop the yoyo in the air but it wasnt doing that a week ago
Then I would suggest cleaning the bearing again but do not lube it. See if it works better. If it does, it’s an indication that you’ve used too much lube the first time.
Note that I am not an advocate of dry bearings. My preferred method is to apply a small bit of lube and then blow it off with compressed air.