Please Help!!!!!

hey guys,

so i have a Duncan Panda, and one day i was doing off string, and it hit the ground, and the caps fell off. Now they don’t go back on, witch is fine with me but when i try to thumb grind there’s little bumbs about every half inch. It slows down the yoyo by about 90%. Is there any way i can take them of without destroying the yoyo ??? ??? ??? :frowning: :frowning: :frowning: :-\ :-\ :-\ :‘( :’( :‘( :’(

Yes, but it would take some pacience, and modding skills.

You need to set it up on a Drill, and sand them off.

OK, i have no modding skills

The caps should go back on. Are you pressing them in evenly? Pushing on one side only will make it hard to put it back on.

~Jump

if i were to put the caps back in, it would not be able to thumb grind any more!
not that it can now :smiley:

i have this problem with my freehand exept my caps broke getting them off. you can sand them off with regular samd paper or i would just get another yoyo.

I don’t think the Panda was meant for thumb grinds. But if you insist, try sanding the bumps down by hand. Just make sure you do each bump slowly; you don’t want recesses where the bumps used to be because you sanded too much.