I am that way with some textures. Was sorting laundry and accidentally touched a microfiber rag when expecting cotton. Screamed a little lol.
Polyfill also feels like death. I have to wear gloves to handle it.
1 Like
Fwiw, as someone who loves the RBC, the Plasm is just scaled up just ever so slightly
2 Likes
I should have a green one and a purple today to share comparisons
2 Likes
Those look like they would make nice half swaps.
1 Like
I just got my package today with a green and purple.
The green certainly has a different hand-feel, and it is slightly tackier, but still pull-startable for certain (and Tape Measure).
The frosted ones are incredibly smooth, the green is just slightly less, but still wayyyy more manageable than I would have expected from a gloss look.
2 Likes
Wanted to update and let you know that i was able to work things out with the retailer. In the end I’ve got 2 B grades, but again that’s fine. Excited to see what color ways come if there’s another run in the future. Loving the feel of the Plasm. Nicely done!
4 Likes
My black b-grade doesn’t have the MK1/SW engraving on it, and it looks so clean without it. I love the engraving, but im not missing it at all
4 Likes
@AudreySickburn - How are you dying yours? Just tossing it in a bucket or RIT?
1 Like
Just got my purp-b in the mail today, mine did have engravings.
I wonder if your non-engraved implies that someone is getting one with 2 engraved halves lol
2 Likes
That would actually be sick too to have both halves engraved
I just assumed since the halves were cracked they just didn’t bother engraving. Cool to know i just got an outlier
pur-bl?
1 Like
I’m using the heated bed on one of my 3d printers to heat the vat of Rit to 94 degrees Celsius. I did not science the measurements, wipe the plasm down, or do anything I probably should have done.
The cabal was done after a couple hours. Here’s a shot of it.
The plasm took almost 20 hours to get a decent pink color. It eventually got a little condensation inside the caps and I have it drying right now in a filament dryer (hot air and desiccants)
You can see the condensation in these photos.
11 Likes
For anyone curious, who may have been a part of the Flying Lemon protos. The 4mm MR85 fits in the Plasm beautifully with the existing axle. If you want to push it a little more into the string-stack realm.
It Skin the Gerbils like a champ! 
7 Likes
Those look great and pretty evenly colored
1 Like
I had to keep flipping the halves every few hours because they float 
3 Likes
Anything for perfection
1 Like
So the plasm does float!!! Maybe I have a new beach YoYo’s and can let the honeybadger rest. Maybe
5 Likes
