So I’ve had this case for a bit and it got no use after a while so i decided to make it a yoyo case . Any suggestions on how i could make this fit 8 yoyos , im gonna take off the lid foam and velcro some pouches up there for strings , lube , silicone , counterweights, etc .im just hesitant to start pulling foam before i know itll work for sure .
2 Likes
I’ve seen folks use a soup can to cut the holes. You’ll just want to make sure to use one with a large enough diameter. Maybe a little undersized so them yo-yos fit snug.
I have a few pick apart foam cases. My suggestion is count how many squares you have going horizontally. Then account for the pieces that separate the yo-yos. For example, my small case was 12 across so I did squares (3x3 on the outside). I did do the middle as 4x4 to keep it symmetrical. For yours, how many squares total across and down?
21 across and 11 down i was just gonna wing the symmetry thing lol
Assuming the yo-yos will fit fine in 4x4 slots I’d do this:
Yo-yos sit in the dark spots, so left to right you’ll remove 4, skip 2, remove 4, skip 1, remove 4, skip 2, remove 4.
Top to bottom is just remove 4, skip 3, remove 4.
If that doesn’t make sense reach out and I’ll try to explain better.
that makes complete sense let me give it a shot right now
1 Like
