Ok, so I have a mosquito that I rim satined, then glued a dif pad on, because I kept falling off.
So to the subject. I can’t open up my mosquito. The axle isn’t stripped or anything,its just the hex key isn’t connected to the plastic, so It is just spinning around.
Any way I can fix this? I never really touched it or anything…
yes, the post above me probably has it. You see, misquitos have a faulty screw system, where if you push the axle in even a little bit, the unglued rubber case inside the yoyo that keeps the hex nut in may come out. That is why I glue those rubber stoppers down.
no need to apologize. the only thing I can currently think of is drilling a hole in the center if the cap and pouring epoxy into the hex nut cavity and letting it cure. Unless its the nut side. then I don’t know.