# Recess problems
**URL:** https://forums.yoyoexpert.com/t/recess-problems/21452
**Category:** Yo-Yo Mods and Maintenance
**Created:** [December 2, 2010, 11:32pm UTC](https://forums.yoyoexpert.com/t/recess-problems/21452 "2010-12-02T23:32:55Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@titanium221](https://forums.yoyoexpert.com/u/titanium221)
#### Post date: [December 2, 2010, 11:32pm UTC](https://forums.yoyoexpert.com/t/recess-problems/21452/1 "2010-12-02T23:32:55Z")
Hey guys, I pad recessed a new FHZ today with .555 dif pads. However, I went a little too deep, making binds slippy. Any ideas of something to use as a sort of shim to bring the pad up to flush?
Thanks
---
### Author:  [@FlyingPotato](https://forums.yoyoexpert.com/u/FlyingPotato)
#### Post date: [December 2, 2010, 11:54pm UTC](https://forums.yoyoexpert.com/t/recess-problems/21452/2 "2010-12-02T23:54:40Z")
You could take out the pads and recess it with RTV silicon. I think you want the pads though.
Hmm, I have no responsibility to what happens to your yoyo but, i would take a little bit of thin super glue. Like the glue is very liquidy; almost like water. Put sum into the recess and let it dry throughly over night. Put the pads back in and it should be raised. I haven’t tried it, though. If i had this problem, thats what I would do.
Hope you solve your problem!
---
### Author:  [@anonyo](https://forums.yoyoexpert.com/u/anonyo)
#### Post date: [December 3, 2010, 12:07am UTC](https://forums.yoyoexpert.com/t/recess-problems/21452/3 "2010-12-03T00:07:00Z")
Since you can recess, the best way is epoxy. Get you some 5 minute epoxy, mix it like it says and fill it either to where you want it or fill it up and re-recess it. I’ve practically coined the epoxy mod with my supafly’s. I take a profly, fill in the transaxle recess since it’s much bigger than the bearing and spacer I use (duncan). Then I cut it to where the duncan bearing spacer fits and viola.
Trust me on this.