# Fellhoelter Drop **URL:** \ **Category:** Up & Coming Manufacturers\ **Created:** [October 23, 2024, 3:20pm UTC](https://forums.yoyoexpert.com/t/fellhoelter-drop/412244 "2024-10-23T15:20:55Z")\ **Posts on this page:** 1\ **Showing post:** 63
**Author:** ![Fellhoelter](https://sea1.discourse-cdn.com/flex015/user_avatar/forums.yoyoexpert.com/fellhoelter/32/286497_2.png) [@Fellhoelter](https://forums.yoyoexpert.com/u/Fellhoelter)\ **Post date:** [November 3, 2024, 5:04pm UTC](https://forums.yoyoexpert.com/t/fellhoelter-drop/412244/63 "2024-11-03T17:04:35Z")
Hey, the site is working again! It seemed to be down for me far a couple of days, not sure if it was for everyone. I figured out the current issue. 100% MY fault. When I made all of these parts, I went through, and measured every single part. If they were oversized, (There wasn’t many that were) I put them in a little box on my bench to use as setup pieces for the 2nd operation. Turning them in to Kisses, or Orbs, what have you, without testing, and possibly scrapping a good part… They should have been tossed in the bin after that was done. Well, I got a new employee in the middle of this project. While I was training him up, I didn’t communicate clearly that the parts in that bin were trash, so probably as many a dozen, that are larger than I would like, made it in to circulation. Most of those, will still work. A few, are simply too big. My screw up, I own it, and apologize. If yours is too big, reach out, I’ll make it right. --- _[View the full topic](https://forums.yoyoexpert.com/t/fellhoelter-drop/412244)._